• GrymEdm@lemmy.world
    44·
    14 days ago

    Finally a voice of reason - I don’t know which psychos are giving up screwing for a whole month, but I have things to fasten.

  • davidagain@lemmy.world
    16·
    14 days ago

    That’s 16 nuts in a 30 day month. It’s not no nut November and it’s not non stop nut November, it’s intermittent nut November.

    • davidagain@lemmy.world
      9·
      14 days ago

      Or, if you prefer,

      No nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, nut, no nut, Nut, Nut, NUT.

  • phant@lemmy.world
    16·
    14 days ago

    Tee Nuts are annoying coz there are also T Nuts, which are used in aluminium extrusion channels. And there’s also Tea Nuts which are nuts you put in tea if you are low on iron.

  • Limonene@lemmy.world
    12·
    14 days ago

    Any regular hex nut works just fine as a jam nut. Basically, a jam nut is when you jam two nuts together. (It is gay, because the nuts do touch.)

    And note that those nylon inserts kinda only work once. The bolt carves a thread into the insert when you insert it, so it will be weaker the second time you insert it.

    Honorable mention: cage nuts. A square nut, permanently attached to a fastener that can snap into a special square hole in a 19 inch server rack. When you tighten the bolt against the nut, it tightens against the fastener, so that the nut, bolt, and fastener are secure against the square hole.

        • EddoWagt@feddit.nl
          3·
          14 days ago

          You can’t easily spin them in hard to reach places, making it difficult to attach or take a long time to fasten/remove

  • FollyDolly@lemmy.world
    5·
    13 days ago

    If we could all stop using wrenches on the wing nut wings and snapping them off that would be great. Either get the wing nuts with the wrench base or hand tighten only!