My two cents: don’t look at anything inside that car at all. Listen to the engine to know when to shift, go a speed that feels comfortable and is a bit slower than other cars. Forgive yourself when the engine stalls or you drive in the ‘wrong’ gear for a bit. If you got behind the wheel and didn’t hit anything, you’re won driving.
This is going to sound stupid, but don’t forget to activate bed levelling after performing the leveling measurements. Maybe this is a stupid idea but I put M29 L1 and M29 A at the start of my gcode to load the ubl slot 1 mesh and activate it. Before getting ubl I used M420 S.
I spent way too much time frustrated by bad prints before I learned that leveling wasn’t active.