No worries at all! Glad it’s all sorted!
No worries at all! Glad it’s all sorted!
Have all these prints been sliced at the same time? (Like on the same version of the slicer)
I had an issue on my filament printer where I thought it was messing up, so I tried a few different prints to make sure and it was still failing. But it turned out that it was caused by a buggy Cura update
The trial is currently going on in Oxford and I think is going pretty well. The primary issue I’ve found is that the infrastructure just isn’t good enough to keep up with this use, and so pedestrians, cyclists, and e-scooter riders are all uncomfortably close together considering their vastly different speeds.
If we improve the infrastructure though, I think they’re great.
Would highly recommend volunteering with SJA, thoroughly enjoyable and rewarding
That looks brilliant! Can’t wait to follow its progress